Dri-Design has announced innovative technology that allows virtually any image to be sculpted into the company’s architectural panels. The new Ombrae Imaging Technology uses an advanced computer software system to cut three-dimensional pixels into Dri-Design panels. Any image—from a graphic design or corporate logo to a photograph or illustration—can be created. From the Latin word meaning “many shadows,” the Ombrae technology breaks down an image into individual pixels. Each pixel’s optimal reflective position is then calculated and punched into the Dri-Design wall panels. Engineered to stay attached to the base panel, the 3-D pixels act as reflectors to catch light or cast a shadow. This creates an almost-holographic image that presents slightly-differing appearances depending upon the lighting and viewing angle. “There’s really nothing like this in the metal industry,” according to Brad Zeeff, president of Dri-Design. “This proprietary process has been in development for more than two years and we’re delighted to bring it to the marketplace. These architecturally expressive panels have the potential to really challenge the imagination of designers.” Intended for both exterior and interior applications, the Dri-Design with Ombrae architectural metal wall panels have all of the durability, ease of installation and environmental friendliness of traditional Dri-Design panels. Dri-Design panels can be made from a variety of materials including Kynar painted and anodized aluminum, zinc, copper and stainless steel. All Dri-Design panels are 100 percent recyclable. For more information on the Dri-Design Wall Panel System, call 616-355-2970 or visit www.dri-design.com.